ICND2 | 200-105 Interconnecting Cisco Networking Devices Part 2

When using cloud computing, if users are reporting slow access to resources, what would be the main cause of the degradation in the user’s experience?

Refer to the |h %5coutput%5ct6%5cmisc%5c200105eo201.html exhibit. What is the purpose of router A in the network diagram?

Which command is used to globally enable BPDU guard on a switch?

Which tool is used to verify basic Layer 3 connectivity between two devices?

You have purchased a new Cisco Catalyst switch. You want to configure it so that it will actively attempt to become a trunk when connected to a neighboring switch interface that is able to become a trunk. Which command should you use?

When configuring HSRP, which of the following priority levels would elect the "active" router in a HSRP group?

Which two commands are used for basic OSPFv2 configuration in a single area? (Choose two.)

You unbox a new Cisco switch that has not been configured. By default, which VLAN will be used by connected devices and for management purposes?

Which command would you use to verify the state of the GRE tunnel?

You are configuring a PPP link between two devices using a serial connection. Your organization's security policy requires PAP authentication to be used when the remote device does not support CHAP. Which command should you use to authenticate incoming PPP sessions?

In what configuration mode would you set the HSRP version using the standby version command?

Which physical WAN topology provides suboptimal traffic flow?

If congestion occurs on an interfaces configured to use QoS, which congestion management tool is activated only when there is congestion?

Refer to the |h %5coutput%5ct6%5cmisc%5c200105eo225.html command output. Which statement is true concerning the details in the output?

Which two statements describe pure distance vector routing protocols? (Choose two.)

You have determined bidirectional communication is not occurring between two OSPF neighbors. What is used to ensure that bidirectional communication is working?

You need to determine the type of cable that is connected to a serial interface. Which command should you use?

You have a 1 Gb/s interface that will be used for routing OSPF. A few devices currently have 100 Mb/s connections. What should you do to ensure that the interface costs are calculated accurately?

Refer to the |h %5coutput%5ct6%5cmisc%5c200105eo228.html exhibit. Which set of commands should you use to ensure that there are no routing table issues?

You need to monitor basic end-to-end WAN connectivity between HQ and the branch office. You want to test end-to-end connectivity every 15 seconds and if connectivity is not successful you need to be notified. What should you do?

Which protocol is used for exchanging routes between two different autonomous systems?

Which three items can be used to verify Layer 3 end-to-end connectivity? (Choose three.)

Which command can you use to verify the values that are being used in the EIGRP metric composition?

Which command is optional when configuring a GRE tunnel?

Which physical WAN topology provides a high level of redundancy?

Which two statements regarding the OSPF router ID are true? (Choose two.)

Which protocol is an example of an EGP?

Which two PAgP mode combinations will allow an EtherChannel link to be formed? (Choose two.)

When prioritizing voice traffic with QoS, what are some of the characteristics that need to be accounted for?

Which type of traffic is described as bursty, greedy with regards to bandwidth required, and drop-sensitive?

At which layer of the OSI model does DHCP snooping operate?

What is the maximum number of switches that can be connected together using StackWise?

Which type of ACL has a usable range of 100-199 and can be matched to a source or destination on an individual port basis?

You only want VLAN 10, 15, and 20 to traverse the trunk between two switches. Which command should you use?

Which protocol allows you to create EtherChannels in a multivendor environment?

Refer to the |h %5coutput%5ct6%5cmisc%5c200105eo229.html partial command output for the show ip eigrp topology command. Which two routes are feasible successors? (Choose two.)

Your organization plans to deploy SNMP to collect information from network devices for diagnostic and maintenance purposes. Why would you suggest implementing SNMPv3?

Which SNMPv3 level of security requires authentication only?

In which service model does the customer only manage applications and data?

Which two statements are true with respect to OSPF or BGP? (Choose two.)

Which two routing protocols depend on directly connected neighbors for their view of the network? (Choose two.)

Which of the following are characteristics of RADIUS? (Choose three.)

Which of the following is considered a trusted device in terms of QoS? (Choose two)

What is used in an SDN deployment to provide communication between the controller and the various network devices?

Which command is used to display OSPFv3 related interface information?

What is the name of the Cisco SDN controller for Enterprise Networks?

Which IPv6 command is required to be the first command executed on a router when configuring EIGRP?

When configuration an EtherChannel between two switches, which mode creates an EtherChannel unconditionally without dynamic negotiation?

Which Cisco service allows an administrator to examine the path that a specific type of packet travels as it makes its way across the network from a source to a destination node?

Refer to the |h %5coutput%5ct6%5cmisc%5c200105eo236.html partial command output.

Which command was used to produce the partial output?

Which technology is typically used for provider-managed VPNs?

Which is a layer of an SDN solution that is responsible for forwarding traffic?

Refer to the following commands:

R1(config)# ip access-list standard Subnet_ONLY
R1(config-std-nacl)# permit 10.1.1.0 0.0.0.255

What is being configured in this example?

QoS can use different types of mechanisms for classification and marking. Which of the following fields is used to indicate Layer 3 IPv4 packets?

Which standard defines identity-based networking?

While calculating your results take a moment to complete our simple survey!

How likely is it that you would recommend TestPrep.Academy to a friend or colleague?